Latch Lock-MLK

MISUMI standard style.

The magnetic switch is the first in China. Two lock modules are mainly made of special permanent magnetic materials. When the three-platen mold is opened, the two lock modules are first drawn together by their own pure permanent magnetic force, so that the fixed mold template and the movable mold template are temporarily immobile. When the fixed mold seat plate and the runner push plate have reached their limit positions successively , And finally rely on the system’s pulling force to exceed the magnetic limit of the magnetic switch to separate the fixed mold template and the movable mold template to achieve the sequence of opening molds. When you want to adjust the magnetic force of the magnetic switch, you only need to open the gap between the two clamping blocks to achieve the required magnetic force. The installation is simpler, faster and more convenient. It only needs to be installed on the side of the fixed mold template and the movable mold template of the mold. There is no precision requirement. It does not need to be processed on the surface of the fixed mold template and the movable mold template. This shortens the mold manufacturing cycle. The accuracy has no effect.

The magnetic switch has good temperature resistance and is not affected by the temperature rise. Permanent magnetic force mold locking, no external interference, better performance. It has a long service life and does not need to be replaced. The magnetic attenuation will not exceed 1% within five years. The tension adjustment pole magnetic switch is an environmentally friendly product, and it is convenient to install and unload. A set of magnetic switch can be used for different molds and recycled. Played a role in saving resources, green and environmental protection. Compared with mechanical shutters and nylon shutters, it is a more cost-effective mold locking product.

• Compared with other clamping devices, it is easier to install.
  Compared with other types of mold lock, the speed of mold closing is not affected, and the forming cycle is shortened
• Install the adsorption surface parallel to the parting surface.
  Finish the template surface to make the adsorption surface stick together tightly.
• If you are concerned about broken bolts, use shoulder bolts
• When using MSB, the countersunk head hole should be machined on the template.
• It is recommended that the aperture tolerance of countersunk head hole be about H7.
• Please use more than 2 sets of magnetic clamping module symmetrically.
• The default temperature is no more than 80°C, and high temperature resistance (up to 200°C) requires customization.